Preventive Maintenance

Preventive Maintenance (PM) visits are scheduled to verify and ensure the proper operation of your equipment. PM is recommended to maximize equipment uptime by identifying and correcting potential problems before they happen. PM visits also allow for ongoing system performance and energy efficiency optimization based on your evolving facility needs.

During a PM visit, Vette Service Technicians will perform the following:

Preventive Maintenance (PM)

Check the state and operation of Rear Door Heat Exchanger units

Remove particulates trapped in the coil faces

Straighten damaged coil fins as needed

Release air from any bleed points as needed

Check the condition of the system fluid

Clean the pumping unit filters

Top-up or flush/replace treated fluid in secondary loop

Log the operational characteristics of the pumping system for predictive maintenance

Retrieve and store log and alarm data from any CDU units

Upgrade firmware if needed or requested (Clients are given prior notice)

Perform any Engineering Change Orders (ECO) on equipment as needed

Check the hose assemblies and quick-connect points for active or dried leakage and wear

Check the hose assemblies for damage

Vette’s Preventive Maintenance contracts (PM) can be ordered individually or in planned renewal intervals. Common customer requests are for 6-month & 1-year service intervals.

Custom contracts can be quoted as needed.

NOTE: Preventive Maintenance visits cannot be substituted for un-scheduled maintenance visits. Credit for future PM visits can be used to offset the cost of un-scheduled maintenance visits on out-of-warranty equipment only if arrangements are approved by Vette Global Services.

Quick Contact

Corporate Headquarters USA
Vette Corp
14 Manchester Square
Suite 210
Portsmouth, NH 03801
Tel: (+1) 603-570-3480
Fax: (+1) 603-570-3481
Email: info@vettecorp.com